cable length

英 [ˈkeɪbl leŋθ]

美 [ˈkeɪbl leŋθ]

链（英国608英尺，美国720英尺）；电缆长度；线长；电线长度

英英释义

noun

• a nautical unit of depth
  Synonym:cablecable's length

双语例句

• Measurement of the Coaxial Cable Length
  同轴电缆长度的测量
• The calculation for construction control of the bridge is made with 3D Bridge program and the unstressed cable length method is used to control the final target status of the bridge in the spacial program.
  施工控制计算采用3DBridge进行，并在空间程序上利用无应力索长法控制斜拉桥最终目标状态。
• What is the maximum cable length between PC and camera ( s)?
  再PC与照相机之间的电缆最长是多少？
• In the oil and gas field development process, the well depth measured by measuring the length of running cable, but the current cable length measurement mainly by motor and Martin Dyke wellhead two measurement methods.
  油气田开发过程中的井深测量是通过测电缆运行长度来实现的，而目前对电缆长度计量主要有井口马达和马丁代克两种计量方式。
• The influence of skin current waveform on core voltage is studied. The effects of the starting and ending resistance change on core voltage and the change relation of core voltage with cable length are also researched.
  研究了皮电流波形对芯电压的影响、电缆始末端电阻变化对芯电压的影响以及芯电压随电缆长度的变化关系。
• Starting from the pre-stressed state, the tension force was calculated by controlling the initial cable length.
  从预应力状态开始，通过控制索原长来追踪索在施工中的张拉力。
• According to the mechanic characteristics of this system, the bearing cable, the stress-free cable length of carry cable and the meticulous algorithm of suspension force of each span are given, and the influence of gentle cable elongation on its dead weight is presented.
  文中根据该系统的力学特点，给出了承重索、轨索的无应力索长和各跨吊杆力的精细算法，并计入了柔索伸长对其自重集度的影响。
• In this paper, to avoid the current-contact measurement of the drawbacks, a laser Doppler Effect based on the non-contact cable length measurement is used.
  本文针对现行接触式测量所存在的弊端，采用了一种基于激光多普勒效应的非接触式电缆长度测量方法。
• And then the effect of the change of cable length and span and the redistribution of dead load due to deformation on cable curve are analyzed.
  分析了索长变化、跨度变化及主缆变形引起的恒载重分布对主缆线形的影响。
• Under the conditions of given initial mid-span deflection, the cable length increment and load increment were obtained by means of the mid-span deflection increment.
  在给定初始跨中挠度的条件下，利用跨中挠度增量值求得索长增量值与载荷增量值；